Durango 2WD V8-5.7L VIN 2 (2007)
REPAIR PROCEDURE USING SOFTWARE UPDATE CD TO RETRIEVE THE FLASH FILE:
NOTE: If this flash process is interrupted/aborted, the flash should be restarted.
NOTE: For detailed information on the operation of the StarSCAN(R) or equivalent, refer to the Quick Reference documentation provided in the
StarSCAN(R) or equivalent documentation kit.
1. Open the hood, install a battery charger and verify that the charging rate provides approximately 13.5 volts. Set the battery charger timer to
maintain the charging voltage for the duration of the flash process.
2. Connect the CH9404 StarSCAN(R) or equivalent vehicle cable to the StarSCAN(R) or equivalent and the vehicle.
3. Power ON the StarSCAN(R) or equivalent.
4. Retrieve the old ECU part number. Using the StarSCAN(R) or equivalent at the "Home"screen:
a. Select "ECU View"
b. Touch the screen to highlight the PCM in the list of modules.
c. Select "More Option"
d. Select "ECU Flash"
e. Record the part number at the top of the "Flash PC" screen for later reference.
5. Replace the PCM with the appropriate Generic PCM. Refer to the detailed service information available in TechCONNECT, under: Service Info,
8-Electrical, Electronic Control Module, Powertrain Control Module, Removal.
6. Insert the StarSCAN(R) or equivalent Software Update CD into the TechCONNECT or equivalent PC. The StarSCAN(R) or equivalent Software
Update CD will start automatically. Select "Download Flash Updates"
7. At the "Select a method for looking up controller flash updates." screen:
a. Select "Enter part number" Enter the "Part Number"recorded in STEP 4 when prompted to do so.
b. Using the mouse highlight the appropriate "Calibration" Select "Next"
c. Follow the on screen instructions.
d. When completed, proceed to STEP 8.
8. With the StarSCAN(R) or equivalent powered OFF, connect the USB Key and Gender Changer to the StarSCAN(R) or equivalent USB port.
9. Connect the StarSCAN(R) or equivalent to the vehicle (if not already connected).
10. Power ON the StarSCAN(R) or equivalent.
11. Download the flash file from the USB key to the StarSCAN(R) or equivalent. Using the StarSCAN(R) or equivalent at the "Home"screen:
a. Select "Flash Download" then select "Retrieve files from the USB storage device"
b. Highlight the appropriate calibration. Select "Download to Scan Too"
c. When the download is complete, select "Close"and "Back"
12. Reprogram the ECU. Using the StarSCAN(R) or equivalent at the "Home"screen:
