dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Impact Sensor|Removal|Page 9044 > < Impact Sensor|Removal|Page 9042
Page 2
background image

1. Reach through the large access hole in the inner door panel to position the side impact sensor (4) within the door.

2. Reconnect the door wire harness connector (2) to the sensor connector receptacle.

3. Position the sensor onto the door beam (1) within the door. Be certain that the anti-rotation pin on the back of the sensor is engaged in the

clearance hole of the door beam.

4. Install and tighten the screw (3) that secures the sensor to the door beam. Tighten the screw to 6 Nm (50 in. lbs.).

5. Reinstall the trim onto the inside of the front door.

6. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed

following service of any supplemental restraint system component.

Side - C-Pillar

SIDE - C-PILLAR

WARNING:  To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.

WARNING:  To avoid serious or fatal injury, never strike or drop the side impact sensor, as it can damage the impact sensor or affect its
calibration. The side impact sensor enables the system to deploy the side curtain supplemental restraints. If an impact sensor is accidentally
dropped during service, the sensor must be scrapped and replaced with a new unit. Failure to observe this warning could result in accidental,
incomplete, or improper front supplemental restraint deployment.

1. Check to be certain that the rivet nut used to secure the side impact sensor (3) is properly installed in the inner C-pillar (5), and that it is in good

condition.

Impact Sensor|Removal|Page 9044 > < Impact Sensor|Removal|Page 9042