Durango 2WD V8-5.7L VIN 2 (2007)
9. Remove the lower trim (2) from the inside of the B-pillar (4)
10. Remove the screw (3) that secures the belt web guide (1) to the B-pillar.
11. Disconnect the body wire harness connector (5) from the seat belt tensioner initiator on the retractor (7).
12. Disconnect the second body wire harness connector from the seat belt switch connector receptacle on the retractor.
13. Remove the screw (8) that secures the upper retractor bracket to the B-pillar.
14. Remove the screw (6) that secures the lower retractor bracket to the B-pillar.
15. Disengage the engagement tab on the upper retractor bracket from the engagement slot in the B-pillar.
16. Remove the front seat belt and retractor from the B-pillar as a unit.
Second Row - Center
SECOND ROW - CENTER
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. Fold and tumble the left outboard second row seat for easiest access to the center seat back left hinge bracket cover (1).
2. Remove the three screws (2) that secure the cover to the center seat back left hinge bracket (3) and remove the cover.
