Durango 2WD V8-5.7L VIN 2 (2007)
Ambient Temperature Sensor / Switch HVAC: Service and Repair
Heating and Air Conditioning
Removal
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove the push pin (3) that secures the ambient air temperature sensor (1) to the inside of the front bumper beam.
3. Disconnect the wire harness connector (2) from the ambient air temperature sensor and remove the sensor from the vehicle.
Installation
INSTALLATION
1. Connect the wire harness connector (2) to the ambient air temperature sensor (1).
2. Position the ambient air temperature sensor to the inside of the front bumper beam.
3. Install the push pin (3) that secures the ambient air temperature sensor to the front bumper beam.
4. Reconnect the negative battery cable.