Durango 2WD V8-5.7L VIN 2 (2007)
1. Check to be certain that the rivet nut (4) used to secure the front wiper module (6) is properly installed in the support at the left front fender ledge,
and that it is in good condition.
2. Position the front wiper module to the cowl plenum panel (1) as a unit.
3. Install and tighten the three screws (2) that secure the module bracket to the cowl plenum panel and the left front fender ledge. Tighten the screws
to 8 Nm (72 in. lbs.).
4. Install and tighten the screw (3) that secures the module bracket and the center bracket of the cowl grille support (7) to the cowl plenum panel.
Tighten the screw to 8 Nm (72 in. lbs.).
5. Reconnect the wire harness connector (5) to the front wiper motor connector.
6. Reinstall the cowl plenum cover/grille panel over the front wiper module.
7. Reinstall both front wiper arms onto the wiper pivots.
8. Reconnect the battery negative cable.
