Durango 2WD V8-5.9L VIN Z LDC (2000)
Antenna Cable: Service and Repair
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIRBAGS AND SEAT BELTS/AIRBAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.
REMOVAL
Antenna Body And Cable
1. Disconnect and isolate the battery negative cable.
2. Remove the trim cover from the right cowl side inner panel.
Antenna Coaxial Cable Routing
3. Reach under the instrument panel below the glove box to access and disconnect the antenna coaxial cable connector. Disconnect the connector
by pulling it apart while twisting the metal connector halves. Do not pull on the cable.
4. Disengage the antenna coaxial cable from the retainer clips on the lower instrument panel reinforcement and the heater-A/C housing.
5. Disengage the antenna coaxial cable retainers at the right cowl side inner panel and inside the right front fender.
