Durango 2WD V8-5.9L VIN Z LDC (2000)
INSTALLATION
NOTE: If the PDC is being replaced with a new unit, be certain to transfer each of the blade-type fuses, cartridge fuses and relays from the faulty
PDC to the proper cavities of the replacement PDC.
1. Position the PDC and the headlamp and dash wire harness unit in the engine compartment.
2. Install the two PDC mounts onto the two stanchions of the battery tray.
3. Install and tighten the screw that secures the PDC housing to the left front fender wheel housing. Tighten the screw to 7.9 Nm (70 in. lbs.).
4. Install the eyelet of the battery positive cable PDC take out onto the forward B(+) terminal stud in the PDC.
5. Install and tighten the nut that secures the eyelet of the battery positive cable PDC take out to the forward B(+) terminal stud in the PDC. Tighten
the nut to 9 Nm (80 in. lbs.).
6. Install the eyelet of the battery negative cable generator output take out onto the rearward B(+) terminal stud in the PDC,
7. Install and tighten the nut that secures the eyelet of the battery negative cable generator output take out to the rearward B(+) terminal stud in the
PDC. Tighten the nut to 9 Nm (80 in. lbs.).
8. Engage the engine wire harness in the trough on the back of the PDC housing and secure it with the retainer clip.
9. Reconnect the engine wire harness in-line connector to the PDC in-line connector receptacle.
10. Install and latch the cover onto the PDC.
11. Engage each of the retainers that secure the headlamp and dash wire harness to the vehicle body and chassis components.
12. Install all of the fasteners that secure each of the headlamp and dash wire harness ground eyelets to the vehicle body and chassis components.
13. Reconnect each of the headlamp and dash wire harness connectors.
14. Reconnect the battery negative cable.
