Durango 2WD V8-5.9L VIN Z LDC (2000)
Canister Purge Solenoid: Service and Repair
Fig. 22 - Duty Cycle EVAP Canister Purge Solenoid
The Duty Cycle EVAP Canister Purge Solenoid is located at the left-rear side of engine compartment near power brake vacuum unit.
REMOVAL
1. Disconnect electrical wiring connector at solenoid
2. Disconnect vacuum harness at solenoid.
3. Remove 2 support bracket mounting nuts.
4. Remove solenoid and its support bracket from vehicle.
INSTALLATION
1. Position EVAP canister purge solenoid and its mounting bracket.
2. Install mounting nuts and tighten to 8 Nm (75 in. lbs.) torque.
3. Connect vacuum harness and wiring connector.
