Durango 4WD V8-4.7L Flex Fuel (2008)
Panel Trim/Quarter Trim Panel - Installation.
7. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed
following service of any SRS component. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests.
Side - D-Pillar
SIDE - D-PILLAR
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
WARNING: To avoid serious or fatal injury, never strike or drop the side impact sensor, as it can damage the impact sensor or affect its
calibration. The side impact sensor enables the system to deploy the side Supplemental Restraint System (SRS) components. If an impact sensor
is accidentally dropped during service, the sensor must be scrapped and replaced with a new unit. Failure to observe this warning could result
in accidental, incomplete, or improper side SRS component deployment.
1. Check to be certain that the rivet nut used to secure the side impact sensor (4) is properly installed in the inner quarter panel forward of the C-pillar
(3), and that it is in good condition.
2. Position the side impact sensor near the inner quarter panel.
3. Reconnect the body wire harness connector (2) to the sensor connector receptacle.
4. Position the sensor onto the inner quarter panel. Be certain that the anti-rotation pin on the back of the sensor is engaged in the clearance hole (1)
of the quarter panel.
5. Install and tighten the screw (5) that secures the sensor to the inner quarter panel. Tighten the screw to 6 Nm (50 in. lbs.).
6. Reinstall the quarter trim panel onto the lower D-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Quarter
Panel Trim/Quarter Trim Panel - Installation.
7. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed
following service of any SRS component. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests.
