Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
Driver/Vehicle Information Display: Removal and Replacement
Electronic Vehicle Information Center
ELECTRONIC VEHICLE INFORMATION CENTER
1. Disconnect and isolate the battery negative cable.
2. Remove the overhead console from the headliner.
3. Remove the screws (1) that secure the Electronic Vehicle Information Center (EVIC) (2) to the overhead console housing (3).
4. Remove the EVIC from the overhead console housing.
Bulb - EVIC Control
BULB - EVIC CONTROL
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
NOTE: There are provisions for up to four bulb/bulb holder units on the Electronic Vehicle Information Center (EVIC) circuit board. The two outboard
bulbs illuminate the EVIC push buttons, while the two center bulbs illuminate the optional universal transmitter push buttons. Therefore, the center bulb
locations are only populated on vehicles equipped with the optional universal transmitter.
1. Disconnect and isolate the battery negative cable.