Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
2. Install the fasteners (1) holding the motor to the seat adjuster (2). Tighten the screws to 5 Nm (44 in. lbs.).
3. Connect the motor electrical connector.
4. Install the seat cushion.
5. Clip the wire harness to cushion pan.
6. Install the seat assembly.
7. Connect the battery negative cable.
8. Verify normal operation of the power seat assembly.
HEIGHT ADJUST MOTOR
1. Ensure the seat adjuster (2) is in the full up position by pulling upward on the upper adjuster assembly.
2. Position motor (3) on seat adjuster (2).
3. Install the motor shaft screw and washer and tighten until snug. Do not torque screw at this time.
