Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
Electronic Brake Control Module: Service and Repair
Removal
REMOVAL
NOTE: ABM module can be removed without removing the HCU unit.
1. Remove the left front tire and wheel assembly.
2. Disconnect the electrical connector from the ABM module.
3. Remove the module mounting screws (2).
4. Remove the module from the HCU (1) on ESP vehicles be careful not to damage the pressure sensor or not to touch the sensor terminals on the
HCU side or the contact pads on the ABM side when removing the ABM.
