Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
Camshaft: Service and Repair
Camshaft - Installation
Camshaft - Left
INSTALLATION
1. Lubricate camshaft journals with clean engine oil.
NOTE: Position the left side camshaft so that the camshaft sprocket dowel is near the 1 o'clock position, This will place the camshaft at
the neutral position easing the installation of the camshaft bearing caps.
2. Position the camshaft into the cylinder head.
3. Install the camshaft bearing caps, hand tighten the retaining bolts.
4. Working in 1/2 turn increments, tighten the bearing cap retaining bolts starting with the middle cap working outward.
5. Torque the camshaft bearing cap retaining bolts to 11 Nm (100 in. lbs.).
6. Position the camshaft drive gear into the timing chain aligning the V8 mark between the two marked chain links (Two links marked during
removal) (1).
