Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
7. Position the rear air inlet housing (6) onto the rear HVAC housing (1).
8. Install the screws (5) that secure the rear air inlet housing to the rear HVAC housing. Tighten the screws to 2 Nm (17 in. lbs.).
9. Connect the rear HVAC wire harness (2) to the rear blower motor (3) and the rear blower motor resistor (4).
10. Install the rear HVAC housing.
11. If the rear A/C evaporator is being replaced, add 30 milliliters (1 fluid ounce) of refrigerant oil to the refrigerant system. When replacing multiple
A/C system components, refer to the Refrigerant Oil Capacities chart to determine how much oil should be added to the refrigerant system. Use
only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
