Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
Hose/Line HVAC: Removal and Replacement
Removal
REMOVAL
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow the
warnings and cautions could result in possible personal injury or death.
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system.
3. Disconnect the wire harness connector (6) from the A/C pressure transducer (5).
4. If required, remove the A/C pressure transducer from the A/C discharge line (1).
5. Remove the nut (7) that secures the A/C discharge line to the A/C condenser (2).
6. Disconnect the A/C discharge line from the A/C condenser and the retainer (3) located on the condenser fan shroud (4).
7. Remove the O-ring seal and gasket from the discharge line fitting and discard.
8. Install plugs in, or tape over the discharge line fitting and condenser port.
9. Remove the nut (1) that secures the A/C discharge line (3) to the A/C compressor (4).
10. Disconnect the A/C discharge line from the A/C compressor and remove and discard the O-ring seal and gasket.
11. Install plugs in, or tape over the opened refrigerant line fitting and the compressor port.
