Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
12. Remove the A/C discharge line from the engine compartment.
Installation
INSTALLATION
CAUTION: Be certain to adjust the refrigerant oil level when servicing the A/C refrigerant system. Failure to properly adjust the refrigerant
oil level will prevent the A/C system from operating as designed and can cause serious A/C compressor damage.
NOTE: When replacing multiple A/C system components, refer to the Refrigerant Oil Capacities chart to determine how much oil should be added to
the refrigerant system.
NOTE: Replacement of the refrigerant line O-ring seals and gaskets is required anytime a refrigerant line is opened. Failure to replace the rubber O-ring
seals and metal gaskets could result in a refrigerant system leak.
1. Position the A/C discharge line into the engine compartment.
2. Remove the tape or plugs from the opened discharge line fitting and the compressor port.
3. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it and a new gasket onto the discharge line fitting. Use only the specified
O-ring as it is made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the
vehicle.
4. Install the A/C discharge (3) line onto the A/C compressor (4).
5. Install the nut (1) that secures the A/C discharge line to the A/C compressor. Tighten the nut to 23 Nm (17 ft. lbs.).
6. Remove the tape or plugs from the opened discharge line fitting (1) and the condenser port (2).
7. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it and a new gasket onto the discharge line fitting. Use only the specified
