Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
29. Install the rear section of the liquid line (2) into the plastic retainer (3) located on the right inner fender (4).
30. Install the air cleaner housing (1) to the right side of the engine compartment.
31. Reconnect the negative battery cable.
32. Evacuate the refrigerant system.
33. Adjust the refrigerant oil level.
34. Charge the refrigerant system.
Removal
REMOVAL
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow the
warnings and cautions could result in possible personal injury or death.
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system.
3. Remove the nut (1) that secure the A/C suction line (2) to the A/C compressor (4).
4. Disconnect the A/C suction line from the A/C compressor and remove and discard the O-ring seal and gasket.
5. Install plugs in, or tape over the opened suction line fitting and the compressor port.
