Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
Turn Signal Bulb: Service and Repair
Front Lamp Unit
Removal
BULB - PARK/TURN SIGNAL OR SIDE MARKER
NOTE: The front lamp unit contains three bulbs: headlamp (3), park/turn signal (2), and side marker (4). Except for the headlamp bulb, the service
procedures for each bulb are the same, only the bulb sizes and types may differ.
1. Disconnect and isolate the battery negative cable.
2. Remove the front lamp unit (1) from the front fender, but do not disconnect the headlamp and dash wiring from the back of the lamp housing.
3. Disconnect the headlamp and dash wire harness connector from the appropriate park/turn signal (2) or side marker (4) bulb socket on the back of
the front lamp unit housing.
4. Firmly grasp the park/turn signal or side marker bulb socket and rotate it counterclockwise about 30 degrees to unlock it.
5. Pull the socket and bulb straight out from the keyed opening in the housing.
6. Pull the base of the bulb straight out of the socket.
Installation
BULB - PARK/TURN SIGNAL OR SIDE MARKER
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
