Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
Auxiliary Power Outlet: Service and Repair
Cigar Lighter/Power Outlet
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Look inside and note position of the retaining bosses (1).
3. Using special tool 9857 Power Outlet Remover. Insert the tool forcing the bosses out of base.
4. Pull out the base through mounting ring by gently rocking the tool (3).
5. Disconnect the base wires.
6. Set base aside and remove base mount ring.
Installation
INSTALLATION
1. Position mount ring to the instrument panel and feed the wires through ring. Index the cap and the mount ring with the index tab at 9 o'clock to the
key in the instrument panel. Install the ring.
2. Connect wires to base. Orient base alignment rib at 11 o'clock to mate the groove in mount ring at the same location.
3. Push base into the bezel till it locks.
4. Install cigar lighter cap.
5. Connect the battery negative cable.
