Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
Power Trunk / Liftgate Control Module: Service and Repair
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the left quarter trim panel from the vehicle.
3. Disconnect the wire harness connectors (2) from the power liftgate control module (4).
4. Using molding remover C-4829-A gently pry the clip (1) out of the retaining hole holding the power liftgate control module (4) to the quarter
panel.
5. Tilt the top of the module (4) away from the quarter panel and lift upward to disengage the mounting tab from the locating slot (3).
6. Remove the power liftgate control module (4) from the vehicle.
