Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
NOTE: The following procedure is for replacement of an ineffective or damaged driver airbag. If the airbag is ineffective or damaged, but not
deployed, review the recommended procedures for handling non-deployed supplemental restraints. If the driver airbag has been deployed, review the
recommended procedures for service after a supplemental restraint deployment before removing the airbag from the vehicle.
1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
2. From the underside of the steering wheel, remove the two screws (3) that secure the driver airbag (1) to the steering wheel armature (2).
CAUTION: Do not pull on the horn switch feed pigtail wire to disengage the connector from the driver airbag housing or to disconnect the
horn switch to steering wheel wire harness connection. Improper pulling on this pigtail wire or connection can result in damage to the horn
switch membrane or feed circuit.
3. Pull the driver airbag (1) away from the steering wheel far enough to access the three electrical connections on the back of the airbag housing.
4. Disconnect the steering wheel wire harness connector for the horn switch (2) from the horn switch feed pigtail wire connector (4), which is located
on the back of the driver airbag housing.
CAUTION: Do not pull on the clockspring pigtail wires or pry on the connector insulator to disengage the connector from the driver airbag
inflator connector receptacle. Improper removal of these pigtail wires and their connector insulators can result in damage to the airbag circuits
or connector insulators.
5. The clockspring driver airbag pigtail wire connectors (3) are secured by integral latches to the airbag inflator connector receptacles, which are
located on the back of the driver airbag housing. Depress the latches on each side of the connector insulator and pull the insulators straight out
from the airbag inflator to disconnect them from the connector receptacles.
6. Remove the driver airbag from the steering wheel.
7. If the driver airbag has been deployed, the clockspring must be replaced.
Installation
INSTALLATION
