Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
8. With all of the hooks disengaged, lift the housing, inflator, and cushion as a unit from the receptacle on the back of the driver airbag trim cover.
Assembly
ASSEMBLY
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
WARNING: To avoid serious or fatal injury, service of this unit should be performed only by DaimlerChrysler-trained and authorized dealer
service technicians. Failure to take the proper precautions or to follow the proper procedures could result in accidental, incomplete, or
improper airbag deployment and possible occupant injuries.
WARNING: To avoid serious or fatal injury, use extreme care to prevent any foreign material from entering the driver airbag, or becoming
entrapped between the driver airbag cushion and the driver airbag trim cover. Failure to observe this warning could result in occupant injuries
upon airbag deployment.
WARNING: To avoid serious or fatal injury, the driver airbag trim cover must never be painted. Replacement trim covers are serviced in the
original colors. Paint may change the way in which the material of the trim cover responds to an airbag deployment. Failure to observe this
warning could result in occupant injuries upon airbag deployment.
NOTE: The following procedures can be used to replace the driver airbag trim cover and horn switch unit for service. If the driver airbag is ineffective
or deployed, the entire driver airbag, trim cover and horn switch must be replaced as a unit.
1. Place the driver airbag on a suitable work surface with the airbag cushion facing up.
2. Fold the two flaps (1) of cushion material up around the sides and over the top of the airbag cushion retainer strap (2).
3. Position the new driver airbag trim cover over the airbag cushion, then push the receptacle of the trim cover down evenly over the cushion. Be
certain that the cushion material flaps remain oriented over the cushion retainer strap as they were in STEP 2.
4. Turn the driver airbag and the new driver airbag trim cover over as a unit, and place the unit on a suitable clean and dry work surface with the
airbag cushion facing down. Be certain to take the proper precautions to prevent the trim cover from receiving cosmetic damage during the
following procedures.
