Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
5. Remove the screw (4) that secures the lower seat belt anchor (3) to the rear floor panel.
6. Remove the quarter trim panel (2) from the lower C-pillar.
7. Route the seat belt lower anchor and turning loop through the access hole in the quarter trim panel.
8. Remove the screw (5) that secures the retractor bracket (1) to the lower C-pillar.
9. Lift the retractor upward far enough to disengage the retractor tab from the engagement hole in the C-pillar.
10. Remove the second row outboard seat belt and retractor from the C-pillar as a unit.
Third Row Center
THIRD ROW CENTER
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. Remove the upper liftgate opening trim from the inside of the rear header (1) in the upper liftgate opening.
2. Route the seat belt (2) and lower anchor latch plates through the clearance hole in the upper liftgate opening trim panel.
3. Pull the top of the left upper D-pillar trim away from the D-pillar far enough to access the retractor mounting provisions.
4. Remove the screw (4) that secures the retractor bracket to the inside of the rear header near the left D-pillar (3).
