Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
5. Remove the third row center seat belt and retractor from the rear header as a unit.
Third Row Outboard
THIRD ROW OUTBOARD
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. Move the third row seat cushion to its storage position, but leave the third row seat back in its upright position for easiest access to the seat belt
lower anchor (2) on the quarter inner panel (3).
2. Remove the screw (1) that secures the lower anchor to the tapping plate on the quarter inner panel.
3. Remove the D-pillar trim panel (1) from the inside of the upper D-pillar.
4. Route the seat belt (2) and lower anchor through the access hole in the D-pillar trim panel.
5. Remove the screw (4) that secures the seat belt turning loop (3) to the inside of the upper D-pillar.
6. Remove the turning loop from the D-pillar.
7. Remove the quarter trim panel from the lower D-pillar.
8. Remove the screw (6) that secures the retractor bracket (5) to the lower D-pillar.
