Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
1. Position the third row center seat belt and retractor (2) to the rear header (1) near the left D-pillar (3) as a unit.
2. Install and tighten the screw (4) that secures the retractor bracket to the inside of the rear header. Tighten the screw to 40 Nm (29 ft. lbs.).
3. Restore the top of the left upper D-pillar trim to its mountings on the D-pillar.
4. Route the seat belt and lower anchor latch plates through the clearance hole in the upper liftgate opening trim panel.
5. Reinstall the upper liftgate opening trim onto the inside of the rear header in the upper liftgate opening.
Third Row Outboard
THIRD ROW OUTBOARD
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. Check to be certain that the molded plastic retractor cup (2) is properly installed in the retractor mounting hole (1) of the inner D-pillar, and that it
is in good condition.
