Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
Seat Belt Height Adjuster: Service and Repair
Installation
Front
FRONT
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. Position the seat belt turning loop adjuster (3) to the B-pillar (2).
2. Install and tighten the two screws (1) that secure the adjuster to the B-pillar. Tighten the screws to 39 Nm (29 ft. lbs.).
3. Reinstall the upper trim (1) onto the inside of the B-pillar.
4. Position the seat belt turning loop (5) onto the height adjuster (2) on the upper B-pillar.
5. Install and tighten the screw (4) that secures the turning loop to the height adjuster. Tighten the screw to 39 Nm (29 ft. lbs.).
