Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
Hood Sensor/Switch (For Alarm): Service and Repair
Installation
Striker
STRIKER
NOTE: The hood ajar switch striker cap is not intended for reuse. If the striker cap is removed from the hood inner reinforcement for any reason, it
must be replaced.
1. Position the new hood ajar switch striker (2) into the large end of the keyed mounting hole (3) in the inner hood panel reinforcement (1) over the
hood ajar switch.
2. Using hand pressure, slide the striker upward into the small end of the mounting hole in the inner hood panel reinforcement until it is fully
engaged.
3. Close and latch the hood.
Switch
SWITCH
1. Position the hood ajar switch (1) near the mounting hole (2) in the left front fender inner shield.
2. Reconnect the wire harness connector (3) to the switch connector receptacle.
3. Insert the switch into the mounting hole until the integral switch latch tabs lock it into place.
4. Reconnect the battery negative cable.