Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
Power Distribution Module: Service and Repair
Module-Front Control
Removal
REMOVAL
1. Disconnect the positive and negative battery cables from the battery.
2. Partially remove the Integrated Power Module (IPM) from the engine compartment.
3. Remove the front control module retaining screws.
4. Pull the front control module straight from the IPM.
Installation
INSTALLATION
1. Press the Front Control Module (FCM) onto the Integrated Power Module (IPM).
2. Install the mounting fasteners.
3. Install the IPM.
4. Connect the positive and negative battery cables.
