Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
14. Using a flash light, verify that glass primer is without damage.
Glass Preparation - Installing A New Backlite
1. Apply four new spacers (1) to the liftgate frame and place them 55 mm in from the window opening; 70 mm from the upper edge and 150 mm
from the lower edge.
2. Install the lower spacers (2) to the backlite approximately 36 cm (1.0 in) from each side of the glass.
NOTE: Remove the lower spacers 2 hours after installation of the glass.
3. Position backlite in center of liftgate opening and resting on the side and lower spacers.
4. Apply adhesive tape strips (1) around the perimeter of the liftgate opening to aid in installation.
NOTE: Windshield installation shown, backlite similar.
5. Verify the backlite gap is parallel to with the liftgate opening.
6. Cut tape with a sharp knife and remove backlite.
