Durango 4WD V8-5.7L Hybrid (2009)
Alarm Module: Service and Repair
Sentry Key Immobilizer Module (SKREEM) - Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component
diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV)
system, a technician trained in proper HEV service safety procedures must also remove the high voltage service disconnect from
the high voltage battery pack. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in
accidental airbag deployment. Failure to follow these instructions may result in possible serious or fatal injury.
1. Position the Sentry Key REmote Entry Module (SKREEM) (1) onto the steering column with the antenna ring (3) oriented around the ignition lock
cylinder housing (4).
2. Install and tighten the screw (2) that secures the SKREEM to the steering column housing. Tighten the screw to 2 Nm (20 in. lbs.).
3. Reconnect the wire harness connector (2) to the SKREEM (1).
4. On vehicles equipped with the optional remote start system, reconnect the coaxial cable to the coaxial connector receptacle on the SKREEM.
