Durango 4WD V8-5.7L Hybrid (2009)
Rear Door Weatherstrip: Service and Repair
Rear Door Outer Belt Weatherstrip - Removal
REMOVAL
1. Insert special tool #9093 (2) between the outer belt molding (1) and glass at the rear.
2. Push down on outer belt molding (1) and rotate upper part of tool (2) outward from vehicle then lift up on molding (1) to disengage from locking
tabs (3) working from back to front.
NOTE: Typical outer belt molding design shown.
3. Slide molding out from under the side view mirror and remove.