Durango 4WD V8-5.7L Hybrid (2009)
10. Install the wiper arm and cowl assembly (1) See: Wiper and Washer Systems/Wiper Arm/Service and Repair/Wiper Arm - Installation.
11. Fill and bleed the brake system. See: Brake Bleeding/Service and Repair.
With ESP
WITH ESP
1. Install the spacer block (3) and gaskets (2) if removed.
2. Guide the booster studs (2) into the cowl panel holes and seat the booster on the panel.
3. Install and tighten new booster attaching nuts to 28 Nm (250 in. lbs.).
4. Install the booster push rod (1) on brake pedal and install clip.
CAUTION: Do not reuse the original stop lamp switch. Anytime a switch has been removed or its position compromised, a new switch must be
installed and adjusted. Do not attempt to readjust the switch.
