Removing Engine Oil Pan on a Durango 4WD V8-57L Hybrid (2009)
Oil Pan: Service and Repair
Engine Oil Pan - Installation
INSTALLATION
WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In
addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High
Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury See: Hybrid Drive
Systems/Battery System, Hybrid Drive/Service Precautions
1. Clean the oil pan gasket mating surface of the block and oil pan.
NOTE: Mopar(R) Engine RTV must be applied to the 4 T-joints (1,2), (area where front cover, rear retainer, block, and oil pan gasket meet).
The bead of RTV should cover the bottom of the gasket. This area is approximately 4.5 mm x 25 mm in each of the 4 T-joint locations.
2. Apply Mopar(R) Engine RTV at the 4 T- joints (1,2).
