Durango 4WD V8-5.7L Hybrid (2009)
8. Verify the throttle body seal is properly aligned at the bottom of the air cleaner housing.
9. Slide the rear air cleaner housing pegs (2) into the grommets (1) on the rear of the intake manifold and lower the front of the air cleaner housing
onto the throttle body.
NOTE: Verify the air cleaner housing is installed properly in the rear grommets by reaching around the left rear corner of the air cleaner
housing and feel for the pegs protruding through the rubber grommets. If the plastic pegs cannot be felt, the air cleaner housing will
need to be reinstalled.
10. Install the air cleaner housing center fastener (2) and tighten to 7 Nm (62 in. lbs.)
11. Install the air cleaner trim cover.
12. Connect the intake air temperature (IAT) sensor electrical connector (1).