Durango 4WD V8-5.7L Hybrid (2009)
Blower Motor Resistor: Service and Repair
Removal - Rear
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove the right rear quarter interior trim panel See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Luggage
Compartment Trim/Quarter Trim Panel - Removal.
3. Disconnect the rear heater-A/C wire harness connector (4) from the rear blower motor resistor (1).
4. Remove the screw (3) that secures the rear blower motor resistor to the rear heater-A/C housing (2).
5. Disengage the rear blower motor resistor from the rear heater-A/C housing and remove the resistor.
