Durango 4WD V8-5.7L Hybrid (2009)
1. Remove the rear heater-A/C housing (1) and place it on a workbench See: Removal and Replacement/Front HVAC Housing Removal.
2. Disconnect the rear heater-A/C wire harness (3) from the rear blower motor resistor (4) and the rear blower motor (2).
3. Remove the rear blower motor resistor .
4. Remove the rear blower motor .
5. Disconnect the rear heater-A/C wire harness (3) from rear blend door actuator (5) and mode door actuator (1).
6. Disengage the rear heater-A/C wire harness from two retaining tabs (2 and 4) located on the top of the rear heater-A/C housing (6) and remove the
wire harness.
7. Remove the rear blend door actuator and mode door actuator See: Air Door/Air Door Actuator / Motor/Service and Repair/Blend Door Actuator -
Removal and See: Air Door/Air Door Actuator / Motor/Service and Repair/Mode Door Actuator - Removal.
NOTE: If the foam seal for the flange is deformed or damaged, the seal be replaced.
8. Carefully remove the foam seal (3) from the rear heater core tube and evaporator line flange (2).
9. Remove the screw (4) that secures the rear heater core tube and evaporator line flange to the outboard side of the rear heater-A/C housing (5).
