Durango 4WD V8-5.7L Hybrid (2009)
17. Remove the twenty screws (3) that secure the two halves of the rear heater-A/C housing (1 and 2) together.
18. Separate the two halves of the rear heater-A/C housing from each other.
NOTE: If the insulator around the A/C evaporator or evaporator tubes is deformed or damaged, the insulator must be replaced.
19. Carefully remove the rear A/C evaporator (1) out of the outboard half of the rear heater-A/C housing (3).
NOTE: If the rubber seal is deformed or damaged, the seal must be replaced.
20. Remove the rubber seal (2) from the rear heater-A/C housing.
NOTE: If a foam seal on an air door is deformed or damaged, the air door must be replaced.
21. Disengage the blend-air door (1) and the mode-air door (2) from the actuator couplers located on the inboard side of the rear heater-A/C housing
(3) and remove the air doors.
