Durango 4WD V8-5.7L Hybrid (2009)
NOTE:
-
depending on the high voltage battery state of charge, it may take up to 60 minutes for the system to become adequately charged to start
the engine.
-
there are remote battery posts located under the hood that are used to assist in the "Jump Assist" procedure.
-
a second running vehicle may be used in this "Jump Assist" procedure provided the generator output is a minimum of 125 amps.
WARNING:
-
a battery generates hydrogen gas which is flammable and explosive. Keep flame or spark away from the vent holes. Do Not use
a booster battery or any other booster source with a nominal voltage output that exceeds 12 Volts.
-
battery fluid is a corrosive acid solution; do not allow battery fluid to contact eyes, skin or clothing. If acid splashes in eyes or
on skin, flush the contaminated area immediately with large quantities of water.
Failure to follow these instructions may result in possible serious or fatal injury.
NOTE:
-
a 12 Volt battery charger with a minimum 30 Amp rating is the only type recommended to use when charging the high voltage battery.
-
depending on the condition of the second running vehicles alternator and the number of accessories operating on both vehicles, it could
take up to 60 minutes to charge the high voltage battery. To minimize the charging time make sure that the minimum amount of
accessories are being used.
WARNING: Always wear eye protection and remove all metal jewelry such as watch bands or bracelets which might make an unintended
electrical contact. Failure to follow these instructions may result in possible serious or fatal injury.
1. Turn off all unnecessary electrical loads such as the heater, radio, lights etc.
2. Set the parking brake, place the transmission in PARK and turn the ignition to the ON/RUN position.
3. Place the battery charger within cable reach of the remote battery posts located under the hood.
4. Connect the positive cable clamp of the 12 Volt battery charger to the remote positive post located near the engine oil dipstick underhood.
5. Connect the negative cable clamp of the 12 Volt battery charger to the remote negative post located near the driver side fender underhood.
WARNING: During cold weather when temperatures are below freezing point, electrolyte in a discharged battery may freeze. Do not attempt
