Durango 4WD V8-5.7L Hybrid (2009)
Fuel Pressure Sensor/Switch: Service and Repair
Fuel Pressure Sensor - Removal
REMOVAL - HEV
WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In
addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High
Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury See: Hybrid Drive
Systems/Battery System, Hybrid Drive/Service Precautions
1. Perform the fuel system pressure release procedure See: Fuel Filter/Fuel Pressure Release/Service and Repair
2. Perform the HEV high voltage power down procedure See: Hybrid Drive Systems/Battery System, Hybrid Drive/Service and Repair/Battery
System - High Voltage Power Down
3. Disconnect the 12 volt battery system ground isolation connector (1).
4. Raise and support the vehicle.
5. Disconnect the fuel fill hose (1) at the rear of the fuel tank.
6. Disconnect the fuel fill vapor line quick-connect fitting (2).