Durango 4WD V8-5.7L Hybrid (2009)
Oil Pressure Sensor: Service and Repair
Oil Pressure Sensor - Installation
INSTALLATION
WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In
addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High
Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury See: Hybrid Drive
Systems/Battery System, Hybrid Drive/Service Precautions
NOTE: Apply Mopar(R) Thread Sealant with PTFE to the sensor threads before installing into the engine block.
1. Install the oil pressure sensor (1).
2. Connect the oil pressure sensor electrical connector (1).
3. Lower the vehicle.
4. Perform the High Voltage Power Up procedure See: Hybrid Drive Systems/Battery System, Hybrid Drive/Service and Repair/Battery System -
High Voltage Power Up