dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Compression Check|Specifications|Page 1192 > < Wheel Tightening Sequence|Page 1186
Page 1
background image

Compression Check: Specifications

Compression should not be less than 689 kPa (100 psi) and not vary more than 172 kPa (25 psi) from cylinder to cylinder.
-

If cylinder(s) have abnormally low compression pressures, repeat procedure.

-

If the same cylinder(s) repeat an abnormally low reading, it could indicate the existence of a problem in the cylinder.

NOTE:  The recommended compression pressures are to be used only as a guide to diagnosing engine problems. An engine should NOT be
disassembled to determine the cause of low compression unless some malfunction is present.

Compression Check|Specifications|Page 1192 > < Wheel Tightening Sequence|Page 1186