Durango 4WD V8-5.9L VIN Z (1998)
Airbag Control Module Remove/Install
5. Remove the three screws that secure the ACM mounting bracket to the floor panel transmission tunnel.
6. Remove the ACM and its mounting bracket as a unit from the floor panel.
7. When installing the ACM, position the unit with the arrow on the ACM housing pointing forward.
8. Attach the ACM to the floor panel transmission tunnel with the four mounting screws. Tighten the mounting screws to 11.8 N.m (105 in. lbs.).
9. Reinstall the screw that secures the instrument panel wire harness ground eyelet to the left side of the floor panel transmission tunnel.
10. Plug in the wire harness connector to the ACM. Be certain that the connector latches are fully engaged and that the connector locks are pushed in.
11. Reverse the remaining removal procedures to complete the installation.
12. Do not connect the battery negative cable at this time. See Airbag System in the Diagnosis and Testing for the proper procedures.
