Durango 4WD V8-5.9L VIN Z (1998)
Malfunction Lamp / Indicator: Testing and Inspection
The diagnosis found here addresses an inoperative airbag indicator lamp condition. If the airbag indicator lamp stays on with the ignition switch in the
On position, or comes on and stays on while driving, refer to Air Bag Systems.
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.
The airbag indicator lamp has a lamp backup feature. Ten seconds after the ignition switch is turned to the On position, if the instrument cluster circuitry
has detected an inoperative airbag warning lamp circuit it will flash the seat belt reminder lamp on and off forthirty seconds. Once the instrument cluster
circuitry has detected an inoperative airbag warning lamp circuit, if a lamp-on message is received from the Airbag Control Module (ACM) on the
Chrysler Collision Detection (CCD) data bus, the seat belt reminder lamp will remain on for the duration of the airbag system malfunction.
If the airbag indicator lamp fails to light when the ignition switch is turned to the On position, and the seat belt reminder lamp flashes following its
normal display function (about six seconds after the ignition switch is turned to the On position), diagnosis of the airbag system and/or the CCD data bus
should be performed with a DRB scan tool as described in the proper Diagnostic Procedures. For further diagnosis of the airbag indicator lamp and the
instrument cluster circuitry, see Instrument Panel, Gauges and Warning Indicators/Instrument Panel/Instrument Cluster in the Diagnosis and Testing.
