Durango RT 4WD V8-5.9L VIN Z LDC (2002)
1. Be certain that the retractor shield is properly installed in the D-pillar and in good condition before installing the retractor.
2. Position the retractor into the D-pillar.
3. Install and tighten the screw that secures the retractor to the D-pillar. Tighten the screw to 40 Nm (29 ft. lbs.).
4. Position the seat belt web guide to the D-pillar above the retractor.
5. Install and tighten the two screws that secure the seat belt web guide to the D-pillar. Tighten the screws to 5 Nm (40 in. lbs.).
6. Reinstall the trim onto the quarter inner panel.
7. Position the lower seat belt anchor plate onto the stud on the quarter inner panel.
8. Install and tighten the nut that secures the lower seat belt anchor plate to the stud on the quarter inner panel. Tighten the nut to 40 Nm (29 ft. lbs.).
9. Position the shoulder belt turning loop onto the D-pillar.
10. Install and tighten the screw that secures the shoulder belt turning loop to the D-pillar. Tighten the screw to 40 Nm (29 ft. lbs.).
11. Snap the trim cover over the third seat shoulder belt turning loop anchor plate to conceal the screw that secures the turning loop to the D-pillar.
