Durango RT 4WD V8-5.9L VIN Z LDC (2002)
NV133 - Transfer Case
REAR RETAINER BUSHING AND SEAL / REMOVAL
1. Raise vehicle.
2. Remove rear propeller shaft.
3. Using a suitable pry tool or slide-hammer mounted screw, remove the rear retainer seal.
4. Using Remover 8158, remove the bushing from rear retainer (Fig. 58).
INSTALLATION
1. Clean fluid residue from sealing surface and inspect for defects.
2. Position replacement bushing in rear retainer with fluid port in bushing aligned with slot in retainer.
3. Using Installer 8157, drive bushing into retainer until installer seats against case (Fig. 59).
