Dynasty L4-153 2.5L SOHC (1988)
cover with contacts facing lock cylinder bore.
13. Install signal switch and wires, then depress hazard warning switch and install screws and torque to 35 inch lbs.
14. Install hazard warning knob and pull knob out, then install inner race, seat, preload spring, cancelling cam and shaft lock.
15. Depress lock plate and install new wire snap ring, then install tilt release lever, turn signal lever, upper shift lever and pivot pin.
16. To install lock, hold lock cylinder sleeve and rotate knob clockwise against stop, then insert cylinder into cover bore with key on cylinder sleeve
aligned with keyway in housing and push in to abutment of cylinder and sector. Install lock retaining screw in housing and torque to 22 in. lbs.
17. Install shaft lock cover and torque retaining screws to 15 inch lbs.
18. To install ignition switch, place lock cylinder in "off-unlock" position, then place ignition switch in "off-unlock" position, by moving slider to the
extreme right and then moving to the left two clicks. Install actuator rod onto slider and using the correct screws, assemble switch onto column.
Lightly push switch downward and torque screws to 35 inch lbs. Use care to avoid moving switch out of detent.
19. Snap wire connector onto column and install wire protector.
20. Install mounting bracket bolts and torque to 22 ft. lbs. Do not use substitute bolts.
21. Install steering wheel and horn parts.
11. Insert key into lock cylinder, turn to "lock" position and remove key. Insert cylinder into housing so that it contacts switch actuator. Insert key,
press inward and rotate cylinder until cylinder locks into housing.
12. Place key cylinder and ignition switch in "lock" position (second detent from top) and tighten ignition switch mounting screws.
13. Remove ignition key. Install buzzer/chime switch wires behind wiring post and down through space between jacket and housing. Position switch in
housing, then install and tighten mounting screws.
14. Install lower bearing support, bearing and spring on steering shaft. Install O-ring in lower groove on upper end of shaft. Insert shaft into column
assembly.
15. Press upper bearing into upper bearing housing, ensuring that bearing is fully bottomed in housing.
16. Install lock plate, upper bearing spring, upper bearing housing and upper bearing housing retaining screws, press steering shaft into column to
compress springs, then install upper bearing snap ring, ensuring that snap ring is fully seated in shaft groove and bearing housing recess.
17. Install ignition key lamp assembly and turn signal switch on bearing housing. Install bearing retainer plate and torque screws to 24 in. lbs. Position
ground wires toward ground clips before torquing.
18. Install ground clips for ignition key lamp and turn signal switch onto bearing retaining plate.
19. Assemble wiper switch, shaft and cover or speed control switch, cover and knob. Install washer/wiper switch assembly into lock housing and
fasten to turn signal switch.
20. Install turn signal lever cover, breakaway capsules and wiring cover over wires and retainers.
