Dynasty L4-153 2.5L SOHC (1988)
12.
Install hangers to the trailing arm.
13.
Install trailing arm bracket to frame.
14.
Install rear coil springs.
15.
Install track bar.
16.
Install lower shock nuts.
17.
Connect brake line brackets.
18.
Connect parking brake cables.
19.
Install rear wheels.
20.
Lower vehicle.
21.
Road test.
The following procedure is unique for vehicles with automatic air suspension.
1.
With vehicle positioned on hoist, lower the rear suspension using the DRB II, refer to the 1991 Air Suspension/Load Leveling Diagnostic
Manual # 81-699-0130.
2.
Disconnect negative battery cable.
3.
Raise vehicle.
4.
Disconnect the air lines to vent the rear air springs.
5.
Disconnect parking brake cables.
6.
Disconnect brake line brackets.
7.
Support the trailing arms.
8.
Remove trailing arm hanger brackets from the frame.
9.
Replace pivot bar bushings using Remover/Installer Special Tool C-4212-L (Press) and 3 piece set, Special Tool 6122 (Receiver Support
Bridge, Bushing Remover/Installer and Bushing Remover).
10.
Connect brake line brackets.
11.
Connect parking brake cables.
12.
Connect air lines.
13.
Recharge the air springs, prior to lowering to avoid pinching the air bag. Refer to the 1991 Front Wheel Drive Car Service Manual,
Publication # 81-270-1101, page 2-80, for recharging procedure.
14.
Lower vehicle.
15.
Connect negative battery cable.
16.
Road test vehicle.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No.
02-30-07-90 . . . . . . . . . . . . . . . . 0.3 Hrs.
Adjust Rear Trailing Arm Hanger Brackets
02-30-07-91 . . . . . . . . . . . . . . . . 1.5 Hrs. Adjust Hanger Brackets And Replace Pivot Bushings (with or without Load Leveling)
02-30-07-92 . . . . . . . . . . . . . . . . 1.2 Hrs. Adjust Hanger Brackets And Replace Pivot Bushings (with Automatic Air Suspension)
