dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Stop Lamps/Cruise Control - Malfunctions|Page 6232 > < Volt Meter Gauge|Description and Operation|Page 6222
Page 1
background image

Technical Service Bulletin # 051392

Date: 921019

Stop Lamps/Cruise Control - Malfunctions

NO.: 
05-13-92

GROUP:
Brakes

DATE:
Oct. 19, 1992

SUBJECT:
Stop Lamps Stay Illuminated/Inoperative Speed Control

NOTE:
THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 05-10- 90 WHICH SHOULD BE REMOVED FROM YOUR FILE.

THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH BENDIX 10 ABS. (1990 AC AND AY BODIES BUILT AFTER MDH 03-26-XX).

THIS BULLETIN SHOULD BE PERFORMED ONLY AFTER TECHNICAL SERVICE BULLETIN 05-08-92 HAS BEEN COMPLETED, AND
DID NOT ELIMINATE THIS CONDITION.

MODELS:

1990-1992
(AC) Dynasty/New Yorker Salon
(AY) Imperial/New Yorker Fifth Avenue
1991-1992
(AS) Caravan/Grand Caravan/Caravan C/V

Voyager/Grand Voyager/Town & Country

SYMPTOM/CONDITION:

Some vehicles equipped with Bendix ABS, may exhibit a condition where the brake pedal may not return to its fully released position. As a result, the
rear stop lamps remain illuminated when the brake pedal has been released or the speed control may be inoperative.

DIAGNOSIS:

Verify that the brake pedal return spring is properly installed. Verify that the stop lamp switch is properly adjusted as outlined in the appropriate service
manual. Ensure that the accumulator is fully charged, by pumping the brake pedal (with the ignition key ON) until the pump comes on, then allow it to
fully charge the accumulator. Depress the brake pedal and slowly release it. Verify that the brake pedal does return to the fully released position, by
pulling up on the pedal and verify that the rear stop lamps go out. If the rear stop lamps go out after pulling up on the pedal, proceed with this repair
procedure.

Stop Lamps/Cruise Control - Malfunctions|Page 6232 > < Volt Meter Gauge|Description and Operation|Page 6222