Dynasty L4-153 2.5L SOHC VIN K TBI (1992)
7.
The DRBII will power up and prompt through the sequence of windows shown:
8.
When the update is complete, turn the vehicle ignition off.
If an error happens, write down the error message (off the Scan Tool Screen). Then press MODE and ATM keys together on the Scan Tool to retry
(reboot). The under hood temperature during programming must be between (minus) -40 degrees F (-40 degrees C) and +185 degrees F (+85
degrees C).
IMPORTANT:
THE NEXT STEPS ARE REQUIRED BY LAW.
9.
Type the necessary information on the "Authorized Software Update Label" and attach to the PCM.
10.
Type the necessary information on the Authorized Modification Label and attach the label near the VECI Label.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
