Dynasty L4-153 2.5L SOHC VIN K TBI (1992)
Compressor/Pump Relay: Service and Repair
Fig. 30 Control Module & Compressor Relay Wiring
REMOVAL
1. Disconnect battery negative cable, then remove trim panel from RH side of trunk.
2. Disconnect electrical connector and relay from control module.
3. Remove control module mounting screws, then the assembly.
INSTALLATION
1.
Install relay on control module bracket, then place control module on bracket and install screws. Torque screws to 19-29 lb-in.
2. Connect relay and module electrical connectors, then replace trim panel.
